Replace Roof Flashing Easily

Replace Roof Flashing Easily
Replacing your damaged roof flashing doesn’t require a professional. With the right tools, you can easily and quickly take out the old flashing and replace it with a new one.

Roof flashings are made up of thin metal plates that help to prevent the seepage of rain water inside the house. This protective layer lies over the top of the wall construction and roof joints, and when it needs replacing, it needs to be done correctly.

To tackle this DIY project, you first need to identify the damaged section of flashing. Once this is done, you can follow these steps to replace the flashing:

1. The first step involves removing any shingles that are around the flashing’s edges. Be careful as you complete this step so the shingles can be reused when you fit the new flashing. To do this, place the back of a hammer at an angle between the shingle and flashing, and tap it with a hammer.

2. Gently remove the flashing from the wall, and then cut a new piece of flashing to the required measurements using a set of metal-cutting snips. Err towards cutting the new flashing a bit bigger – it’s better to trim it down in size afterwards, rather than cutting too small a piece initially.

3. Place the cut piece of flashing at the back of the siding and ensure that it is crimped with a metal break.

4. Place the new flashing over the old and align it with the joints. To secure the shiny, hammer back the shingles located near it.

And that’s it! It’s a relatively simple job that can be done in no time at all.

In the unfortunate event that you do experience water leaks in your roof, don’t hesitate to reach out to a qualified contractor to inspect and replace the old flashing. You can also draw on their knowledge to check that you’re using the right tools to perform the job. When left unchecked, a flashing issue can easily become a bigger and more costly issue.

In conclusion, anyone with the right tools and knowledge can replace the damaged flashing on their roof. Attempting DIY fixes without knowing what you’re doing, however, is imprudent. Remember, safety is key and should come first. When it comes to carrying out more serious repairs, always reach out to a professional.