Utilizing a Butt Gauge for Maximum Strength Gains: Your Complete Guide

Using a butt gauge is an important step to ensure that your doors are properly hung in a new jamb. This type of gage is a measuring tool that makes sure the hinges are placed and sized accurately each time they are installed. The process is easy to follow and very efficient.

To begin, the butt gauge should be set and placed on the door jamb in the same way that a regular square tool would. Then, move the flange to line up evenly with the door jamb’s edge. Mark the position of the hinge with an awl. Next, adjust the width of the hinge and once again, mark it down with the awl. Following the butt gauge, your door jamb should now have three straight lines marking out the area.

The next step is to determine the setback of the hinge. Usually, it is about a 1/4 of an inch in depth. This spot must be cut out in order for the hinge to be placed properly and securely. To chip away at the area and shape it correctly, use a flat chisel. Once the door jamb is all set, you can start the same procedure on the actual door. Keeping the same width and depth measurements as the door jamb, use the butt gauge to line up and mark where the hinge must go.

For any type of swagged hinge, the butt gauge has a small extension feature. This helps to account for the offset of the hinge and ensures that it is installed properly.

When using the butt gauge accurately, you can guarantee that your doors are hung properly each time. It is important to check that all measurements are exactly the same in order to avoid any problems with the hinges. Once you understand and use the butt gauge correctly, hanging doors will be a simple and efficient process.