Step-by-Step Guide to Easily Install Storm Door Screen Clips

Installing a storm screen door clip can seem overwhelming but with the right tools, you can do it in minutes. With a few simple steps, you can rest assured that your security and privacy come first, no matter the weather.

Before you start, you need to measure the area and mark where the clip needs to go. To do this, hold up your panel in front of the door and make a mark where the clip should go. Measure this along the side of the door and mark the spot for the top and bottom clips. It’s essential that these spots line up with the other clip holes.

Once the spots are marked, you’re ready to start drilling. You’ll need to get a drill bit to match the size of the rivet you’re using. Put your drill on slow speed and drill each hole. Make sure to keep a steady speed so you can have more control over the drill.

Now that you have the holes, it’s time to thread the pieces together. Push the stem of the rivet through the first hole and then insert the rivet into the second hole. Then, take your rivet gun, hold down the handle and watch as the rivet is secured to the inside of the door.

When you’re done with the rivet, it’s time to attach the clip to the door. Place the clip over the rivet and then secure with a knurled screw. Do the same with the bottom clip and panel.

Finally, inspect your work. If everything looks good, you’re done! Now you can enjoy your storm screen door with peace of mind. Installing storm screen door clips is a great way to ensure that your privacy is secure and your panels stay in place. Get the most out of your door and protect against insects and weather elements with just a few easy steps.