Learn the Steps to Create a Fantastic Bathroom with Ceramic Tile Installation

Installing ceramic bathroom tile is a great way to add a beautiful and long-lasting flooring surface to your bathroom. To ensure a successful installation, it is important to take the time to measure and lay out the floor before starting, use the correct tools and materials, and to allow the thinset and grout to dry before use. With the steps outlined below, you can be sure to have a successful and beautiful ceramic bathroom tile installation.

Before beginning the installation process, you will need to measure the length and width of the bathroom floor. Multiply the two numbers together to get the area of the floor and then add 10 percent to this figure to allow for extra tile in case of any mistakes or repairs. After measuring the area, you will need to locate the centerpoints of each wall in the bathroom. This can be done by drawing a chalk line from the same corner of each wall and where the lines meet will be the centerpoint.

Once you have the centerpoint determined, the next step is to spread thinset on the floor. Using a trowel, spread some thinset in the corner of the intersection of the two chalk lines. Make sure that the thinset is spread evenly and smoothly on the surface of the floor.

Next, it is time to begin laying down the tile. Place one tile at the center of the room and press it into the thinset, making sure to press it down firmly. Place tile spacers at each corner of the tile and then position the next tile up against the spacers. Continue this process until all the tiles in the center of the room are in place.

When you get to the edge of the room, you may need to cut the tile to fit this area. Take the measurements of the gap and then use a wet saw to cut the tile to size. Once the tile is cut, place it into the gap between the tile and the wall.

It is important to allow the thinset to dry for at least 24 hours before beginning the next step. Once the thinset is dry, you can begin to apply the grout. Use a grout float or trowel to apply the grout to the grout joints. Make sure that all of the joints are filled with grout. After applying the grout, take a sponge with some water to wipe the tile down. This will help remove the extra grout from the tile surface, as well as help smooth out the grout joints.

Finally, allow the grout to dry completely before walking on the tile or beginning to use the bathroom again. With these simple steps, you can be sure to have a successful installation of ceramic bathroom tile.