Learn How to Create a Durable, Stylish Tile Shower Floor to Upgrade Your Bathroom

Once the tiles are laid and set, the grout should be applied. The grouting should start at one corner of the shower floor, followed by the rest of the tiled area. A grout float should be used to firmly apply the grout; this is a rubber trowel that would create an even layer of the grout lines. After the grout is applied, the shower floor should be wiped clean with a damp cloth to remove any excessive grout.\n
When everything dries, it can be sealed with a penetrating sealer. To finish the installation, grout and tile cleaner should be used to clean the surface and make the tile look clear and even.

Laying tiles on the floor of a shower can dramatically improve the look of any bathroom, while also protecting the walls of the shower from water damage. To lay a tile shower floor, there are a few materials needed, along with particular steps to ensure that the tiles are secured and the look is clean and even.

To begin, it is important to pick out the tile which works best for the shower, such as ceramic, porcelain, or even stone tiles. Before finding the laying tile on the floor, one should make sure the size fits properly, and be aware that adjustments may need to be made. Once the tile is picked, pre-slope mortar should be applied over the shower pan, so that any sub-flooring is ready for the tile application.

Next, a backerboard should be installed over the shower pan. This backerboard is then softened with a trowel in order to adhere to the shower pan. After this is softened and cured, a pre-slope mortar should be added in order to provide a base for the tiles. Once the pre-slope mortar is dry and cured, the next step is ready to begin.

Starting with the center of the shower floor, a mark should be made with either a pencil or some tape. This mark should be used as a guide for where to start the tile application. Starting with the center tile, tile the shower floor from the center and work out towards the left until the wall is reached.

Continue to work from the center out to the right, making sure to adjust for the wall tiles, and then continue to the wall against the entrance of the shower. Once these steps are completed and the shower floor looks even from all sides, the next step would then be ready to begin.

The next step is to grout the tiles. To do this, grout should start at one corner of the shower floor, followed by the rest of the tiled area The grout should be applied with a rubber grout float to ensure that the grout is even between all of the tiles. Once the grout is applied, any excess grout should be wiped with a damp cloth.

Once the grout is completely dry and set, a penetrating sealer should be applied to ensure that the tile and grout are Completely waterproof. Once the sealer is applied and dry, grout and tile cleaners can be used to make the tile look even and clear. Finally, enjoy the fully tiled shower floor and all of its new beauty and functionality it brings to the bathroom.